Pair of Crossover PCBs for the AviaTrix-RST MTM DIY speaker design - PCB Kit

Description

Custom printed circuit boards designed for the crossover of the AviaTrix-RST MTM DIY speaker design by Curt Campbell.
Take the guesswork out of crossover assembly, these boards make the process quick and straightforward.
The boards measure 6.65" x 4.5" and feature large solder pads and copper traces for great electrical connectivity
The Crossover PCBs work with either the Sealed or MLTL versions of the Aviatrix-RST MTM.
Note photos of fully assembled crossovers are for reference only.
Includes:
2x Crossover PCBs for the Aviatrix-RST MTM speaker design.
8x Terminal blocks which accept up to 12 gauge wire.
8x Snap in PCB standoffs.
8x Mounting screws (screw finish may vary).
Requires:
Crossover components for the AviaTrix-RST MTM speaker design.
Compatible components tested for fit on this PCB:
C1 & C4 - 500uF - 100v Non-Polarized Capacitor (Bypassed for MLTL Design)
C2, C3 & C5 - 15uF - Dayton Audio DMPC-15
C6 - 1.5uF - Dayton Audio PMPC-1.5
L1 - 3.0mH - Erse 3.0mH 18 AWG I Core -or- Dayton Audio 3.0mH 18 AWG I-Core
L2 - 0.30mH - Jantzen Audio 0.30mH 20 AWG Air Core -or- Dayton Audio 0.30mH 20 AWG Air Core
R1 - 1 Ohm - Dayton Audio DNR-1.0
R2 - 5.6 Ohm - Dayton Audio DNR-5.6
Assembly:
Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.